Balancing Vanguard Satellites

Balancing Vanguard Satellites PDF

Author: A. Simkovich

Publisher:

Published: 1961

Total Pages: 32

ISBN-13:

DOWNLOAD EBOOK →

The Vanguard satellites and component parts were balanced within the specified limits by using a Gisholt Type-S balancer in combination with a portable International Research and Development vibration analyzer and filter, with low-frequency pickups. Equipment and procedures used for balancing are described; and the determination of residual imbalance is accomplished by two methods: calculation, and graphical interpretation. Between-the-bearings balancing is recommended for future balancing of payloads.

Balancing Vanguard Satellites

Balancing Vanguard Satellites PDF

Author: A. Simkovich

Publisher:

Published: 1961

Total Pages: 36

ISBN-13:

DOWNLOAD EBOOK →

The Vanguard satellites and component parts were balanced within the specified limits by using a Gisholt Type-S balancer in combination with a portable International Research and Development vibration analyzer and filter, with low-frequency pickups. Equipment and procedures used for balancing are described; and the determination of residual imbalance is accomplished by two methods: calculation, and graphical interpretation. Between-the-bearings balancing is recommended for future balancing of payloads.

Vanguard I Satellite Structure and Separation Mechanism

Vanguard I Satellite Structure and Separation Mechanism PDF

Author: John T. Shea

Publisher:

Published: 1961

Total Pages: 22

ISBN-13:

DOWNLOAD EBOOK →

A reevaluation of the Vanguard program objectives in January 1957 resulted in the production of the Vanguard I Satellite, a 6.44-inch-diameter, 3.25-pound sphere with six equally spaced solar cell clusters and six equally spaced antennas mounted on its surface. Experiment requirements necessitated the development of a mechanism to separate the satellite from the third-stage rocket. On the basis of the existing standard separation mechanism, a strap pull-pin girth-ring arrangement was developed. Both the satellite and the separation mechanism were fully tested prior to flight. Successful orbiting and flight operation proved the adequacy of the design.

Vanguard Satellite Spin-reduction Mechanism

Vanguard Satellite Spin-reduction Mechanism PDF

Author: Robert C. Baumann

Publisher:

Published: 1961

Total Pages: 32

ISBN-13:

DOWNLOAD EBOOK →

The Cloud Cover Satellite flown in Vanguard vehicles SLV-3 and SLV-4 required a spin rate of 55 r.p.m. when entering orbit. Since the third-stage rocket was spin-stabilized in flight, and because other considerations required that the satellite remain attached long enough to acquire more than the desired 55 r.p.m., a satellite spin-reduction mechanism was developed. Although the mechanisms functioned properly in both flights, the desired spin rate was not achieved owing to uncontrollable flight effects. These effects make the prediction of satellite spin rates after a long pre-separation coasting period extremely difficult. To meet future requirements a control system is needed which can orient a payload according to a predetermined scheme and maintain that orientation for the desired period.

Vanguard I Satellite Structure and Separation Mechanism

Vanguard I Satellite Structure and Separation Mechanism PDF

Author: John T. Shea

Publisher:

Published: 1961

Total Pages: 26

ISBN-13:

DOWNLOAD EBOOK →

A reevaluation of the Vanguard program objectives in January 1957 resulted in the production of the Vanguard I Satellite, a 6.44-inch-diameter, 3.25-pound sphere with six equally spaced solar cell clusters and six equally spaced antennas mounted on its surface. Experiment requirements necessitated the development of a mechanism to separate the satellite from the third-stage rocket. On the basis of the existing standard separation mechanism, a strap pull-pin girth-ring arrangement was developed. Both the satellite and the separation mechanism were fully tested prior to flight. Successful orbiting and flight operation proved the adequacy of the design.